4.8 (661) · € 31.99 · En Stock
Dear All, I have a problem I am stuck with it for over a month. I have an Arduino mega connected to 4channel relay module as suggested in the diagram below. I am connected RTC and lcd screen to arduino as well. I am using 2 separate power adapters one for arduino and one for relays. JD-VCC jumper is removed so relays should be isolated from arduino. Relays are connected to 4 x 220v alarm bells. Run for 3 seconds every 45 minutes. Problem: Sometime when the alarm turn off, the LCD screen
HLK-LD2410C Human Motion/Presence Detection Radar Sensor (HCSENS0051)
Relay module effecting Arduino - General Electronics - Arduino Forum
Arduino - 4-Channel Relay Module
Can I drive a two relay module directly from Arduino - #33 by lastchancename - Project Guidance - Arduino Forum
Adding an LED to a circuit - General Electronics - Arduino Forum
Safely using a relay - General Electronics - Arduino Forum
All About Arduino UNO R4
Relay module is active lowhow to reverse that - General Electronics - Arduino Forum
Stuck on activating a relay - Programming Questions - Arduino Forum
Problem with two relay module - Project Guidance - Arduino Forum
Arduino relays. : r/arduino
My first schematic of a 2-channel relay board, Page 2
Arduino Based Voltage Logger